| Model | EETC-12010 | EETC-24010 |
Output
| DC Voltage | 12V | 24V |
| Rated Current | 0.83A | 0.42A |
| Current Range | 0~0.83A | 0-0.42A |
| Rated Power | 10W | 10W |
| Ripple&Noise(Max) | 150mV | 150mV |
| Voltage Tolerance | ±4% | ±4% |
| Setup, Rise Time | 100ms/220VAC |
| Hold Up Time(Typ.) | 80ms/220VAC |
Input | Voltage Range | 90~275VAC |
| Frequency Range | 47~60Hz |
| Power Factor(Typ) | PF>0.6/220VAC |
| Efficiency(Typ) | 80% | 82% |
| AC Current(Typ) | 0.3A/115V 0.25A/235V |
| Inrush Current(Typ) | Cold-star Current 1.4A/235V |
Protection | Short Circuit | Protection type:recovers automatically after fault conditions is removed |
| Overlaod | Overload protection@145~160%above peak rating |
| Over Temperature | Protection typer:shut down o/p voltage.re-power on to recover |
Environment | Working Temp | -30~ +60℃(Refer to output load derating curve) |
| Working Humidity | 20~90%RH no-condensing (Waterproof) |
| Storage Temp & Humidity | '-40~ +80℃、10~90%RH |
Safety & EMC | Safety Standards | CE Mark(LVD),IP67 |
| Withstand Voltage | I/P-O/P:1.5KVAC IP-GND:1.5KVAC |
| Emc Test Standards | EN 55015:2006; EN 61547:1995+A1:2000 ;EN 61000-3-2:2006; EN61000-3-2:1995+A2:2005 EN 61347-1：2008 EN 61347-2-13：2006 |
NOTE | 1.All parameters NOT specially mentioned are measured at 220VAC input,rated laod and 25℃ of ambient temperature. |
| 2.Ripple&noise are measured at 20MHz of bandwidth by using a12''twisted pair-wire terminated with a 0.1uf&10uf parallel capacitor. |
| 3.Tolerance: includes set up tolerance,line regulation and load regulation. |
